Finite element modeling for electric field and voltage distribution along the cap and pin insulators under pollution
1
Electrical Engineering Laboratory (LGE), University of M’sila, M’sila, Algeria.
2
Department of Electrical Engineering, Faculty of Technology, University of M’sila, M’sila Algeria.
Submission date: 2022-11-09
Final revision date: 2022-12-30
Acceptance date: 2023-01-20
Online publication date: 2023-03-20
Publication date: 2023-03-20
Corresponding author
Hani Benguesmia
Department of Electrical Engineering, Faculty of technology, University of M’sila, M’sila Algeria.
Department of Electrical Engineering, Faculty of technology, University of M’sila, M’sila Algeria.
Diagnostyka 2023;24(2):2023201
KEYWORDS
TOPICS
ABSTRACT
The knowledge of the behavior of both the electric potential and electric field is one of the main factors needed when designing an insulator. Using AutoCAD software a 2D cap and pin 1512L insulator model was created in the clean state and under pollution from one to five insulators separately making a chain of insulators for a total of 10 models. Later they are imported to COMSOL Multiphysics 5.6 software, simulations of the 1512L insulator were made to see the effect the pollution has and the differences that occur on the distribution with the addition of more insulators in the chain. The potential distribution starts to develop a pattern after a certain number of insulators in the chain while the pollution induces high value spikes in thefield distribution. Finite-element-analysis for numerical simulation of the pollution effect in outdoor insulators: a review and a novel method.
REFERENCES (14)
1.
Yang M, Yang X, Li X, Wang Z, Wang P. Design and optimization of a solar air heater with off set strip fin absorber plate. Applied Energy. 2014;113:1349-1362. https://doi.org/10.1016/j.apen....
2.
Altaa D, Bilgilib E, Ertekina C, Yaldiza O. Experimental investigation of three different solar air heaters: energy and exergy analyses. Applied energy. 201: 2953-2973. https://doi.org/10.1016/j.apen....
3.
Ho, Kian Tsong, Izadi, Mahdi, Ab Kadir, Mohd Zainal Abidin. EFVD along porcelain insulator using the FEM. Pertanika Journal of Science & Technology, 2017;25:189-196. http://psasir.upm.edu.my/id/ep....
4.
Muniraj C, Chandrasekar S. Finite element modeling for electric field and voltage distribution along the polluted polymeric insulator. Journal of Modelling and Simulation. 2012;8(4):310-320.
5.
M’ziou N, Benguesmia H, Rahali H. Modeling electric field and potential distribution of an model of insulator in two dimensions by the finite element method. International Journal of Energetica. 2018; 3(1):1-5. http://dx.doi.org/10.47238/ije....
6.
Terrab H, Boulanouar H, Bayadi A. Flashover process analysis of non-uniformly polluted insulation surface using experimental design methodology and finite element method.Electric Power Systems Research. 2018;163(Part B):581-589. https://doi.org/10.1016/j.epsr....
7.
Benguesmia H, M’ziou N, Chouchou A.M, Rachdi L. Experimental Study of the various pollution and simulation of potential and electric field distribution using FEMM at a high voltage insulator under alternative current. International Symposium on Computational and Experimental Investigations of Fluid and Structure Dynamics, (CEFSD2015-94). 2015;16-18:144.
8.
Kontargyri VT, Gonos IF, Stathopulos IA. Measurement and simulation of the electric field of high voltage suspension insulators. European Transactions on Electrical Power. 2009;19:509-517. https://doi.org/10.1002/etep.2....
9.
Ghiasi Z, Faghihi F, Shayegani-Akmal AA. et al. FEM analysis of electric field distribution for polymeric insulator under different configuration of non-uniform pollution. ElectrEng. 2021;103:2799–2808. https://doi.org/10.1007/s00202....
10.
Ghiasi Z, Faghihi F, Shayegani-Akmal AA. FEM analysis of electric field distribution for polymeric insulator under different configuration of non-uniform pollution. Electrical Engineering. 2021;103:2799–2808. https://doi.org/10.1007/s00202....
11.
Othman NA, Piah MAM, Adzis Z, Ahmad H, Ahmad NA. Simulation of voltage and electric-field distribution for contaminated glass insulator. 2013 IEEE Student Conference on Research and Development. 2013:116-120. https://doi.org/10.1109/SCOReD....
12.
Arshad, Nekahi A, McMeekin SG, Farzaneh M. Effect of pollution severity on electric field distribution along a polymeric insulator. 2015 IEEE 11th International Conference on the Properties and Applications of Dielectric Materials (ICPADM). 2015:612-615. https://doi.org/10.1109/ICPADM....
13.
Benguesmia H, M’ziou N, Boubakeur A. Simulation of the potential and electric field distribution on high voltage insulator using the finite element method. Diagnostyka. 2018;19(2):41-52. http://dx.doi.org/10.29354/dia....
14.
Benguesmia H, Bakri, Khadar S, Hamrit F, M’ziou N. Experimental study of pollution and simulation on insulators using COMSOL® under AC voltage. Diagnostyka. 2019;20(3):21-29. https://doi.org/10.29354/diag/....
Share
RELATED ARTICLE
| eISSN: | 2449-5220 |
We process personal data collected when visiting the website. The function of obtaining information about users and their behavior is carried out by voluntarily entered information in forms and saving cookies in end devices. Data, including cookies, are used to provide services, improve the user experience and to analyze the traffic in accordance with the Privacy policy. Data are also collected and processed by Google Analytics tool (more).
You can change cookies settings in your browser. Restricted use of cookies in the browser configuration may affect some functionalities of the website.
You can change cookies settings in your browser. Restricted use of cookies in the browser configuration may affect some functionalities of the website.
